LM3410XMFE datasheet(23/49 Pages) TI

23 / 49 page

VOUT + VIN

D =

VOUT

'¶

VOUT

VIN

LM3410, LM3410Q

www.ti.com

SNVS541G – OCTOBER 2007 – REVISED MAY 2013

Figure 24. RθJA vs Internal Dissipation

For 5-pin SOT-23 package typical applications, RθJA numbers will range from 80°C/W to 110°C/W, and RΨJC will

vary between 50°C/W and 65°C/W. These values are for PCB’s with two and four layer boards with 0.5 oz

copper, with two to four thermal vias from GND pin to bottom layer.

Here is a good rule of thumb for typical thermal impedances, and an ambient temperature maximum of 75°C: If

your design requires that you dissipate more than 400mW internal to the LM3410, or there is 750mW of total

power loss in the application, it is recommended that you use the 6-pin WSON or the 8-pin MSOP-PowerPad

package with the exposed DAP.

SEPIC Converter

The LM3410 can easily be converted into a SEPIC converter. A SEPIC converter has the ability to regulate an

output voltage that is either larger or smaller in magnitude than the input voltage. Other converters have this

ability as well (CUK and Buck-Boost), but usually create an output voltage that is opposite in polarity to the input

voltage. This topology is a perfect fit for Lithium Ion battery applications where the input voltage for a single cell

Li-Ion battery will vary between 2.7V and 4.5V and the output voltage is somewhere in between. Most of the

analysis of the LM3410 Boost Converter is applicable to the LM3410 SEPIC Converter.

SEPIC Design Guide:

SEPIC Conversion ratio without loss elements:

(56)

Therefore:

(57)

Small ripple approximation:

In a well-designed SEPIC converter, the output voltage, and input voltage ripple, the inductor ripple IL1 and IL2 is

small in comparison to the DC magnitude. Therefore it is a safe approximation to assume a DC value for these

components. The main objective of the Steady State Analysis is to determine the steady state duty-cycle, voltage

and current stresses on all components, and proper values for all components.

In a steady-state converter, the net volt-seconds across an inductor after one cycle will equal zero. Also, the

charge into a capacitor will equal the charge out of a capacitor in one cycle.

Therefore:

Submit Documentation Feedback

Product Folder Links: LM3410 LM3410Q

LM3410XMFE Datasheet(PDF) 23 Page - Texas Instruments