LM3410XMFE datasheet(24/49 Pages) TI

No. de pieza	LM3410XMFE

Descripción Electrónicos	525kHz/1.6MHz, Constant Current Boost and SEPIC LED Driver with Internal Compensation

PDF	49 Pages

Scroll/Zoom	100%

Fabricante Electrónico	TI [Texas Instruments]

Página de inicio	http://www.ti.com

Logo

24 / 49 page

VIN =

)

VOUT

VC3 =

)

VOUT

AREA

( )

(s)

§ D

IL1

and

§ '

ILED

LM3410, LM3410Q

SNVS541G – OCTOBER 2007 – REVISED MAY 2013

www.ti.com

(58)

Substituting IL1 into IL2

IL2 = ILED

(59)

The average inductor current of L2 is the average output load.

Figure 25. Inductor Volt-Sec Balance Waveform

Applying Charge balance on C1:

(60)

Since there are no DC voltages across either inductor, and capacitor C3 is connected to Vin through L1 at one

end, or to ground through L2 on the other end, we can say that

VC3 = VIN

(61)

Therefore:

(62)

This verifies the original conversion ratio equation.

It is important to remember that the internal switch current is equal to IL1 and IL2 during the D interval. Design the

converter so that the minimum ensured peak switch current limit (2.1A) is not exceeded.

Submit Documentation Feedback

Product Folder Links: LM3410 LM3410Q

LM3410XMFE Datasheet(PDF) 24 Page - Texas Instruments