SCF5250 datasheet(14/56 Pages) FREESCALE

14 / 56 page

SCF5250 Data Sheet: Technical Data, Rev. 1.3

Freescale Semiconductor

3.4

Chip Selects

There are three chip select outputs on the SCF5250 device. CS0/CS4 and CS1/QSPI_CS3/GPIO28 and

CS2 which is associated with the IDE interface read and write strobes - IDE-DIOR and IDE-DIOW.

CS0 and CS4 are multiplexed. The SCF5250 has the option to boot from an internal Boot ROM.

The function of the CS0/CS4 pin is determined by the boot mode. When the device is booted from internal

ROM, the internal ROM is accessed with CS0 (required for boot) and the CS0/CS4 pin is driven by CS4.

When the device is booted from external ROM / Flash, the CS0/CS4 pin is driven by CS0 and the internal

ROM is disabled.

The active low chip selects can be used to access asynchronous memories. The interface is glueless.

3.5

ISA Bus

The SCF5250 supports an ISA bus. Using the ISA bus protocol, reads and writes for one ISA bus

peripheral is possible. IDE-DIOR/GPIO31 and IDE-DIOW/GPIO32 are the read and write strobe. The

peripheral can insert wait states by pulling IDE-IORDY/GPIO33.

CS2 is associated with the IDE-DIOR and IDE-DIOW.

3.6

Bus Buffer Signals

As the SCF5250 has a complicated slave bus, which allows SDRAM, asynchronous memories, and ISA

peripherals on the bus, it may become necessary to introduce a buffer on the bus in certain applications.

The SCF5250 has a glueless interface to steer these bus buffers with two bus buffer output signals

BUFENB1/GPIO29 and BUFENB2/GPIO30.

3.7

I2C Module Signals

There are two I2C interfaces on this device as described in Table 4.

The I2C module acts as a two-wire, bidirectional serial interface between the SCF5250 processor and

peripherals with an I2C interface (e.g., LED controller, A-to-D converter, D-to-A converter). When

devices connected to the I2C bus drive the bus, they will either drive logic-0 or high-impedance. This can

be accomplished with an open-drain output.

Table 4. I2C Module Signals

I2c Module Signal

Description

I2C Serial Clock

The SCL0/SDATA1_BS1/GPIO41 and SCL1/TXD1/GPIO10 bidirectional signals are the clock signal for

first and second I2C module operation. The I2C module controls this signal when the bus is in master

mode; all I2C devices drive this signal to synchronize I2C timing.

Signals are multiplexed

I2C Serial Data

The SDA0/SDATA3/GPIO42 and SDA1/RXD1/GPIO44 bidirectional signals are the data input/output for

the first and second serial I2C interface.

Signals are multiplexed

SCF5250 Datasheet(PDF) 14 Page - Freescale Semiconductor, Inc

SCF5250 Datasheet(HTML) 14 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Datasheet Descarga

Enlace URL