SCF5250 datasheet(17/56 Pages) FREESCALE

17 / 56 page

SCF5250 Data Sheet: Technical Data, Rev. 1.3

Freescale Semiconductor

3.12

Subcode Interface

There is a 3-line subcode interface on the SCF5250 processor. This 3-line subcode interface allows the

device to format and transmit subcode in EIAJ format to a CD channel encoder device. The three signals

are described in Table 9.

3.13

Analog to Digital Converter (ADC)

The ADOUT signal on the ADOUT/SCLK4/GPIO58 pin provides the reference voltage in PWM format.

This output requires an external integrator circuit (resistor/capacitor) to convert it to a DC level to be input

to the ADREF pin.

The six AD inputs are each fed to their own comparator. The reference input to each (ADREF) is then

multiplexed as only one AD comparison can be made at any one time.

NOTE

To use the ADINx as General Purpose inputs (rather than there analogue function) it is

necessary to generate a fixed comparator voltage level of VDD/2. This can be

accomplished by a potential divider network connected to the ADREF pin. However in

portable applications where stand-by power consumption is important the current taken

by the divider network (in stand-by mode) could be excessive. Therefore it is possible to

generate a VDD/2 voltage by selecting SCLK4 output mode and feeding this clock signal

(which is 50% duty cycle) through an external integration circuit. This would generate a

voltage level equal to VDD/2 but would be disabled when stand-by mode was selected.

3.14

Secure Digital/Memory Stick Card Interface

The device has a versatile flash card interface that supports both Secure Digital and Memory Stick cards.

The interface can either support one Secure Digital or two Memory Stick cards. No mixing of card types

is possible. Table 10 gives the pin descriptions.

Table 9. Subcode Interface Signal

Signal name

Description

RCK/QSPI_DIN/QSPI_DOUT/GPIO26 Subcode clock input. When pin is used as subcode clock, this pin is driven by the CD

channel encoder.

QSPI_DOUT/SFSY/GPIO27

Subcode sync output

This signal is driven high if a subcode sync needs to be inserted in the EFM stream.

QSPI_CLK/SUBR/GPIO25

Subcode data output

This signal is a subcode data out pin.

Table 10. Flash Memory Card Signals

Flash Memory Signal

Description

EBUIN2/SCLKOUT/GPIO13

Clock out for both Memory Stick interfaces and for Secure Digital

EBUIN3/CMD_SDIO2/GPIO14

Secure Digital command line

Memory Stick interface 2 data I/O

SCF5250 Datasheet(PDF) 17 Page - Freescale Semiconductor, Inc

SCF5250 Datasheet(HTML) 17 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Datasheet Descarga

Enlace URL