STAC9704 datasheet(17/49 Pages) HYNIX

17 / 49 page

SigmaTel, Inc.

STAC9704/7

10/02/98

Within slot 0 the first bit is a global bit (SDATA_IN slot 0, bit 15) which flags whether the

STAC9704/7 is in the "Codec Ready" state or not. If the “Codec Ready” bit is a 0, this indicates that

STAC9704/7 is not ready for normal operation. This condition is normal following the de-assertion of

power on reset, for example, while STAC9704/7’s voltage references settle. When the AC-link "Codec

Ready" indicator bit is a 1, it indicates that the AC-link and STAC9704/7 control/status registers are in

a fully operational state. The AC'97 controller must further probe the Powerdown Control Status

Prior to any attempts at putting STAC9704/7 into operation the AC'97 controller should poll the first bit

in the audio input frame (SDATA_IN slot 0, bit 15) for an indication that STAC9704/7 has become

"Codec Ready". Once the STAC9704/7 is sampled "Codec Ready", the next 12 bit positions sampled

by the AC'97 controller indicate which of the corresponding 12 time slots are assigned to input data

streams, and that they contain valid data. The following diagram illustrates the time slot based AC-link

protocol.

Figure 8: STAC9704/7 Audio Input Frame

SYNC

BIT_CLK

SDATA_IN

valid

Frame

slot1

slot2

End of previous audio frame

slot(12) "0"

"0"

Data Phase

20.8 uS (48 kHZ)

Tag Phase

12.288 MHz

Time Slot "Valid" Bits

Slot 1

Slot 2

Slot 3

Slot 12

("1" = time slot contains valid PCM data)

A new audio input frame begins with a low to high transition of SYNC. SYNC is synchronous to the

rising edge of BIT_CLK. On the immediately following falling edge of BIT_CLK, STAC9704/7

samples the assertion of SYNC. This falling edge marks the time when both sides of AC-link are aware

of the start of a new audio frame. On the next rising of BIT_CLK, the STAC9704/7 transitions

SDATA_IN into the first bit position of slot 0 ("Codec Ready" bit). Each new bit position is presented

to AC-link on a rising edge of BIT_CLK and subsequently sampled by the AC'97 controller on the

following falling edge of BIT_CLK.

This sequence ensures that data transitions, and subsequent

sample points for both incoming and outgoing data streams are time aligned.

STAC9704 Datasheet(PDF) 17 Page - Hynix Semiconductor

STAC9704 Datasheet(HTML) 17 Page - Hynix Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Datasheet Descarga

Enlace URL