USB3370 datasheet(36/75 Pages) MICROCHIP

36 / 75 page

USB3370

DS00001915B-page 36

 2012 - 2015 Microchip Technology Inc.

6.2.2

ULPI REGISTER WRITE

A ULPI register write operation is given in Figure 6-3. The TX command with a register write DATA[7:6] = 10b is driven

by the Link at T0. The register address is encoded into DATA[5:0] of the TX CMD byte.

To write a register, the Link will wait until DIR is low, and at T0, drive the TX CMD on the data bus. At T2 the PHY will

drive NXT high. On the next rising clock edge, T3, the Link will write the register data. At T4, the PHY will accept the

packet. Finally, at T5, the PHY will latch the data into the register and the Link will pull STP low.

NXT

is used to throttle when the Link drives the register data on the bus. DIR is low throughout this transaction since

the PHY is receiving data from the Link. STP is used to end the transaction and data is registered after the de-assertion

of STP. After the write operation completes, the Link must drive a ULPI Idle (00h) on the data bus. If the databus is not

driven to idle the USB3370 may decode the non-zero bus value as an RX Command.

A ULPI extended register write operation is shown in Figure 6-4. To write an extended register, the Link will wait until

DIR

is low, and at T0, drive the TX CMD on the data bus. At T2 the PHY will drive NXT high. On the next clock T3 the

Link will drive the extended address. On the next rising clock edge, T4, the Link will write the register data. At T5, the

PHY will accept the register data and drive NXT low. The Link will drive an Idle on the bus and drive STP high to signal

the end of the data packet. At T5, the PHY will latch the data into the register. Finally, at T6, the Link will drive STP low.

11b

XXXXXXb

Immediate Register Read Command where: DATA[5:0]

= 6-bit register address

101111b

Extended Register Read Command where the 8-bit

FIGURE 6-3:

ULPI REGISTER WRITE IN SYNCHRONOUS MODE

TABLE 6-2:

ULPI TX CMD BYTE ENCODING (CONTINUED)

Command Name

CMD Bits[7:6]

CMD Bits[5:0]

Command Description

DIR

CLK

DATA[7:0]

STP

NXT

TXD CMD

(reg write)

Idle

Reg Data[n]

Idle

ULPI Register

Reg Data [n-1]

Reg Data [n]

USB3370 Datasheet(PDF) 36 Page - Microchip Technology

USB3370 Datasheet(HTML) 36 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

Datasheet Descarga

Enlace URL