AT89C51CC03U-RDTIM datasheet(96/195 Pages) ATMEL

No. de pieza	AT89C51CC03U-RDTIM

Descripción Electrónicos	Enhanced 8-bit MCU with CAN Controller and Flash Memory

PDF	195 Pages

Scroll/Zoom	100%

Fabricante Electrónico	ATMEL [ATMEL Corporation]

Página de inicio	http://www.atmel.com

Logo

96 / 195 page

AT89C51CC03

4182I–CAN–06/05

•

Enable General CAN IT in the interrupt system register,

•

Enable interrupt by message object, EICHi,

•

Enable interrupt on error, ENERCH.

To enable an interrupt on general error:

•

Enable General CAN IT in the interrupt system register,

•

Enable interrupt on error, ENERG.

To enable an interrupt on Buffer-full condition:

•

Enable General CAN IT in the interrupt system register,

•

Enable interrupt on Buffer full, ENBUF.

To enable an interrupt when Timer overruns:

•

Enable Overrun IT in the interrupt system register.

When an interrupt occurs, the corresponding message object bit is set in the SIT

To acknowledge an interrupt, the corresponding CANSTCH bits (RXOK, TXOK,...) or

CANGIT bits (OVRTIM, OVRBUF,...), must be cleared by the software application.

When the CAN node is in transmission and detects a Form Error in its frame, a bit Error

will also be raised. Consequently, two consecutive interrupts can occur, both due to the

same error.

When a message object error occurs and is set in CANSTCH register, no general error

are set in CANGIE register.

AT89C51CC03U-RDTIM Datasheet(PDF) 96 Page - ATMEL Corporation