STSPIN32F0 datasheet(23/40 Pages) STMICROELECTRONICS

No. de pieza	STSPIN32F0

Descripción Electrónicos	Three-phase gate drivers

PDF	40 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

23 / 40 page

DocID029806 Rev 2

23/40

STSPIN32F0

Device description

Figure 10. Linear regulator output characteristics

Note:

The linear regulator is designed to supply the internal circuitry only and must not be used to

supply external components.

6.4

Standby mode

The device is forced into the standby mode to reduce power consumption forcing both the

OC_TH_STBY1 and OC_TH_STBY2 analog IC inputs low (see Table 12).

When the standby mode is set the analog IC is put into the low consumption mode after

a tsleep time, in particular:



The linear regulator is switched off



All the output drivers are forced low (external power switches turned off)



Op amps and comparators disabled



The DC/DC regulator remains operative.

When the device exits from the standby mode a set time is necessary to recover a proper

value of the 12 V internal regulator. This set time is strictly dependent by the capacitor

connected on the VREG12 pin and can be calculated with Equation 1.

STSPIN32F0 Datasheet(PDF) 23 Page - STMicroelectronics