UPSD325X datasheet(61/176 Pages) STMICROELECTRONICS

61 / 176 page

61/176

µPSD325X DEVICES

Table 44. Description of the SCON Bits

Bit

Symbol

Function

SM0

(SM1,SM0)=(0,0): Shift Register. Baud rate = fOSC/12

(SM1,SM0)=(1,0): 8-bit UART. Baud rate = variable

(SM1,SM0)=(0,1): 8-bit UART. Baud rate = fOSC/64 or fOSC/32

(SM1,SM0)=(1,1): 8-bit UART. Baud rate = variable

6SM1

5SM2

Enables the multiprocessor communication features in Mode 2 and 3. In Mode 2 or 3, if

SM2 is set to ’1,’ R1 will not be activated if its received 8th data bit (RB8) is ’0.’ In Mode

1, if SM2=1, R1 will not be activated if a valid Stop Bit was not received. In Mode 0, SM2

should be ’0’

REN

Enables serial reception. Set by software to enable reception. Clear by software to

disable reception

3TB8

The 8th data bit that will be transmitted in Modes 2 and 3. Set or clear by software as

desired

2RB8

In Modes 2 and 3, this bit contains the 8th data bit that was received. In Mode 1, if

SM2=0, RB8 is the Snap Bit that was received. In Mode 0, RB8 is not used

1TI

Transmit interrupt flag. Set by hardware at the end of the 8th bit time in Mode 0, or at the

beginning of the Stop Bit in the other modes, in any serial transmission. Must be cleared

by software

0RI

Receive interrupt flag. Set by hardware at the end of the 8th bit time in Mode 0, or

halfway through the Stop Bit in the other modes, in any serial reception (except for

SM2). Must be cleared by software

UPSD325X Datasheet(PDF) 61 Page - STMicroelectronics