Production Data

WM8775

w

PD Rev 4.1, June 2006

7

TERMINOLOGY

1.

Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full scale output and the output

with no signal applied. (No Auto-zero or Automute function is employed in achieving these results).

2.

Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal.

Normally a THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB

to it. (e.g. THD+N @ -60dB= -32dB, DR= 92dB).

3.

THD+N (dB) - THD+N is a ratio, of the rms values, of (Noise + Distortion)/Signal.

4.

Stop band attenuation (dB) - Is the degree to which the frequency spectrum is attenuated (outside audio band).

5.

Channel Separation (dB) - Also known as Cross-Talk. This is a measure of the amount one channel is isolated from

the other. Normally measured by sending a full scale signal down one channel and measuring the other.

6.

Pass-Band Ripple - Any variation of the frequency response in the pass-band region.

MASTER CLOCK TIMING

MCLK

t

MCLKL

t

MCLKH

t

MCLKY

Figure 1 Master Clock Timing Requirements

Test Conditions

PARAMETER

SYMBOL

TEST CONDITIONS

MIN

TYP

MAX

UNIT

System Clock Timing Information

MCLK System clock pulse width

high

11

ns

MCLK System clock pulse width

low

11

ns

MCLK System clock cycle time

28

1000

ns

MCLK Duty cycle

40:60

60:40

Power-saving mode activated

After MCLK stopped

2

10

µs

Normal mode resumed

After MCLK re-started

0.5

1

MCLK

cycle

Table 1 Master Clock Timing Requirements

Note:

If MCLK period is longer than maximum specified above, power-saving mode is entered. In this power-saving mode, all

registers will retain their values and can be accessed in the normal manner through the control interface.