5.6 Electrical Characteristics (continued)

minimum and maximum specifications are at TA = –40°C to 125°C, AVDD = 3.0V to 5.5V, DVDD = 2.7V to 5.5V, VINP =

–50mV to 50mV, VINN = 0V, and sinc3 filter with OSR = 256 (unless otherwise noted); typical specifications are at TA = 25°C,

CLKIN = 20MHz with 50% duty cycle, AVDD = 5V, and DVDD = 3.3V

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

POWER SUPPLY

IAVDD

High-side supply current

6.2

8.0

mA

IDVDD

Low-side supply current

CLOAD = 15 pF

4.5

7.0

mA

AVDDUV

High-side undervoltage detection

threshold

AVDD rising

2.4

2.6

2.8

V

AVDD falling

1.9

2.05

2.2

DVDDUV

Low-side undervoltage detection

threshold

DVDD rising

2.3

2.5

2.7

V

DVDD falling

1.9

2.05

2.2

(1)

This parameter is input referred.

(2)

Integral nonlinearity is defined as the maximum deviation from a straight line passing through the end-points of the ideal ADC transfer

function expressed as number of LSBs or as a percent of the specified linear full-scale range FSR.

(3)

Offset error temperature drift is calculated using the box method, as described by the following equation:

TCEO = (EO,MAX – EO,MIN) / TempRange where EO,MAX and EO,MIN refer to the maximum and minimum EO values measured within the

temperature range (–40 to 125

℃).

(4)

Gain error temperature drift is calculated using the box method, as described by the following equation:

TCEG (ppm) = ((EG,MAX - EG,MIN) / TempRange) x 104 where EG,MAX and EG,MIN refer to the maximum and minimum EG values (in %)

measured within the temperature range (–40 to 125

℃).

(5)

THD is the ratio of the rms sum of the amplitudes of first five higher harmonics to the amplitude of the fundamental.

AMC0106M05

SBASAS7A – AUGUST 2024 – REVISED JUNE 2025

www.ti.com

8

Submit Document Feedback

Copyright © 2025 Texas Instruments Incorporated

Product Folder Links: AMC0106M05