ST7LITE1XB datasheet(63/157 Pages) STMICROELECTRONICS

63 / 157 page

ST7LITE1xB

63/157

DUAL 12-BIT AUTORELOAD TIMER 4 (Cont’d)

11.2.3.4 Output Compare Mode

To use this function, load a 12-bit value in the

Preload DCRxH and DCRxL registers.

When the 12-bit upcounter CNTR1 reaches the

value stored in the Active DCRxH and DCRxL reg-

isters, the CMPFx bit in the PWMxCSR register is

set and an interrupt request is generated if the

CMPIE bit is set.

In single Timer mode the output compare function

is performed only on CNTR1. The difference be-

tween both the modes is that, in Single Timer

mode, CNTR1 can be compared with any of the

four DCR registers, and in Dual Timer mode,

CNTR1 is compared with DCR0 or DCR1 and

CNTR2 is compared with DCR2 or DCR3.

Notes:

1. The output compare function is only available

for DCRx values other than 0 (reset value).

2. Duty cycle registers are buffered internally. The

CPU writes in Preload Duty Cycle Registers and

these values are transferred in Active Duty Cycle

Registers after an overflow event if the corre-

sponding transfer bit (TRANx bit) is set. Output

compare is done by comparing these active DCRx

values with the counters.

Figure 42. Block Diagram of Output Compare Mode (single timer)

DCRx

OUTPUT COMPARE CIRCUIT

COUNTER 1

(ATCSR)

CMPIE

PRELOAD DUTY CYCLE REG0/1/2/3

ACTIVE DUTY CYCLE REGx

CNTR1

TRAN1

(ATCSR2)

OVF

(ATCSR)

CMPFx (PWMxCSR)

CMP

REQUEST

INTERRUPT

ST7LITE1XB Datasheet(PDF) 63 Page - STMicroelectronics

ST7LITE1XB Datasheet(HTML) 63 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL