MPC8313ECVRAFDA datasheet(38/100 Pages) FREESCALE

38 / 100 page

MPC8313E PowerQUICC™ II Pro Processor Hardware Specifications, Rev. 2.1

Freescale Semiconductor

High-Speed Serial Interfaces (HSSI)

9.2

SerDes Reference Clocks

The SerDes reference clock inputs are applied to an internal PLL whose output creates the clock used by

the corresponding SerDes lanes. The SerDes reference clocks input is SD_REF_CLK and SD_REF_CLK

for SGMII interface.

The following sections describe the SerDes reference clock requirements and some application

information.

9.2.1

SerDes Reference Clock Receiver Characteristics

Figure 23 shows a receiver reference diagram of the SerDes reference clocks.

•

The supply voltage requirements for XCOREVDD are specified in Table 1 and Table 2.

•

SerDes reference clock receiver reference circuit structure:

— The SD_REF_CLK and SD_REF_CLK are internally AC-coupled differential inputs as shown

in Figure 23. Each differential clock input (SD_REF_CLK or SD_REF_CLK) has a 50-

termination to XCOREVSS followed by on-chip AC coupling.

— The external reference clock driver must be able to drive this termination.

— The SerDes reference clock input can be either differential or single-ended. Refer to the

differential mode and single-ended mode description below for further detailed requirements.

•

The maximum average current requirement that also determines the common mode voltage range:

— When the SerDes reference clock differential inputs are DC coupled externally with the clock

driver chip, the maximum average current allowed for each input pin is 8 mA. In this case, the

exact common mode input voltage is not critical as long as it is within the range allowed by the

maximum average current of 8 mA (refer to the following bullet for more detail), since the

input is AC-coupled on-chip.

— This current limitation sets the maximum common mode input voltage to be less than 0.4 V

(0.4 V/50 = 8 mA) while the minimum common mode input level is 0.1 V above XCOREVSS.

For example, a clock with a 50/50 duty cycle can be produced by a clock driver with output

driven by its current source from 0 to 16 mA (0–0.8 V), such that each phase of the differential

input has a single-ended swing from 0 V to 800 mV with the common mode voltage at 400 mV.

— If the device driving the SD_REF_CLK and SD_REF_CLK inputs cannot drive 50

Ω to

XCOREVSS DC, or it exceeds the maximum input current limitations, then it must be

AC-coupled off-chip.

•

The input amplitude requirement. This requirement is described in detail in the following sections.

MPC8313ECVRAFDA Datasheet(PDF) 38 Page - Freescale Semiconductor, Inc