AD9380SLASHPCB datasheet(11/60 Pages) AD

11 / 60 page

AD9380

Rev. 0 | Page 11 of 60

Mnemonic

Description

POWER SUPPLY1

VD (3.3 V)

Analog Power Supply.

These pins supply power to the ADCs and terminators. They should be as quiet and filtered as possible.

VDD (1.8 V to 3.3 V)

Digital Output Power Supply.

A large number of output pins (up to 27) switching at high speed (up to 150 MHz) generates many power supply

transients (noise). These supply pins are identified separately from the VD pins, so output noise transferred into

the sensitive analog circuitry can be minimized. If the AD9380 is interfacing with lower voltage logic, VDD may be

connected to a lower supply voltage (as low as 1.8 V) for compatibility.

PVDD (1.8 V)

Clock Generator Power Supply.

The most sensitive portion of the AD9380 is the clock generation circuitry. These pins provide power to the clock

PLL and help the user design for optimal performance. The designer should provide quiet, noise-free power to

these pins.

DVDD (1.8 V)

Digital Input Power Supply.

This supplies power to the digital logic.

GND

Ground.

The ground return for all circuitry on chip. It is recommended that the AD9380 be assembled on a single solid

ground plane, with careful attention to ground current paths.

1 The supplies should be sequenced such that VD and VDD are never less than 300 mV below DVDD. At no time should DVDD be more than 300 mV greater than VD or VDD.

AD9380/PCB Datasheet(PDF) 11 Page - Analog Devices

AD9380/PCB Datasheet(HTML) 11 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datasheet Descarga

Enlace URL