WM8741GEDSSLASHV datasheet(29/64 Pages) WOLFSON

29 / 64 page

Production Data

WM8741

PD, Rev 4.2, October 2009

LRCLK POLARITY

In left justified, right justified or I2S modes, the LRP register bit controls the polarity of LRCLK. If this

bit is set high, the expected polarity of LRCLK will be the opposite of that shown in Figure 14, Figure

15 and Figure 16. If this feature is used as a means of swapping the left and right channels, a 1

sample phase difference will be introduced.

BIT

LABEL

DEFAULT

DESCRIPTION

Format Control

05h

LRP

LRCLK polarity select:

0 = normal LRCLK polarity

1 = inverted LRCLK polarity

Table 17 LRCLK Polarity Control

In DSP modes, the LRP register bit is used to select between DSP mode A and B (see Figure 17 and

Figure 18).

BIT

LABEL

DEFAULT

DESCRIPTION

Format Control

05h

LRP

DSP format select:

0 = DSP mode A

1 = DSP mode B

Table 18 DSP Format Control

BCLK / DSDCLK64 POLARITY

In PCM mode, LRCLK and DIN are sampled on the rising edge of BCLK by default, and should

ideally change on the falling edge. Data sources which change LRCLK and DIN on the rising edge of

BCLK can be supported by setting the BCP register bit. Setting BCP to 1 inverts the polarity of

BCLK to the inverse of that shown in Figure 14, Figure 15, Figure 16, Figure 17 and Figure 18.

In DSD mode, DSDL and DSDR inputs are sampled a fixed delay after a falling 64fs clock edge.

When BCP is set in DSD mode, DSDL and DSDR are sampled a fixed delay after a rising 64fs clock

edge.

BIT

LABEL

DEFAULT

DESCRIPTION

Format Control

05h

BCP

BCLK / DSD64CLK polarity select:

0 = normal polarity

1 = inverted polarity

Table 19 BCLK Polarity Control

OVERSAMPLING RATE CONTROL

The user has control of the oversampling ratio of the WM8741, and can set to the device to operate

in low, medium or high rate modes. For correct operation of the digital filtering and other processing

on the WM8741, the user must ensure the correct value of OSR[1:0] is set at all times.

BIT

LABEL

DEFAULT

DESCRIPTION

Mode Control 1

07h

[6:5]

OSR[1:0]

Oversampling Rate Selection

00 = Low rate (32/44.1/48kHz)

01 = Medium rate (96kHz)

10 = High rate (192kHz)

11 = Unused

Table 20 Oversampling Rate Control

WM8741GEDS/V Datasheet(PDF) 29 Page - Wolfson Microelectronics plc

WM8741GEDS/V Datasheet(HTML) 29 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Descarga

Enlace URL