AD9882SLASHPCB datasheet(17/36 Pages) AD

17 / 36 page

REV. A

AD9882

–17–

The COAST function allows the PLL to continue to run at the

same frequency, in the absence of the incoming Hsync signal or

during disturbances in Hsync (such as equalization pulses). This

may be used during the vertical sync period, or any other time

that the Hsync signal is unavailable. Also, the polarity of the

Hsync signal may be set through the Hsync Polarity Bit (Register

10H, Bit 6). If not using automatic polarity detection, the Hsync

polarity bit should be set to match the polarity of the Hsync

input signal.

TIMING (ANALOG INTERFACE)

The following timing diagrams show the operation of the AD9882.

The Output Data Clock signal is created so that its rising edge

always occurs between data transitions and can be used to latch

the output data externally.

DATA

HSOUT

tSKEW

DATACK

tDCYCLE

tPER

Figure 7. Output Timing

Hsync Timing

Horizontal Sync (Hsync) is processed in the AD9882 to elimi-

nate ambiguity in the timing of the leading edge with respect to

the phase-delayed pixel clock and data.

The Hsync input is used as a reference to generate the pixel

sampling clock. The sampling phase can be adjusted, with respect

to Hsync, through a full 360

∞ in 32 steps via the Phase Adjust

Display systems use Hsync to align memory and display write

cycles, so it is important to have a stable timing relationship

between Hsync output (HSOUT) and data clock (DATACK).

Three things happen to Horizontal Sync in the AD9882. First,

the polarity of Hsync input is determined and will thus have a

known output polarity. The known output polarity can be pro-

grammed either active high or active low (Register 10H, Bit 5).

Second, HSOUT is aligned with DATACK and data outputs.

Third, the duration of HSOUT (in pixel clocks) is set via

drive the rest of the display system.

Coast Timing

In most computer systems, the Hsync signal is provided continu-

ously on a dedicated wire. In these systems, the COAST function

is unnecessary and should be disabled using Register 11H, Bits 1–3.

In some systems, however, Hsync is disturbed during the Vertical

Sync period (Vsync). In other cases, Hsync pulses disappear.

In other systems, such as those that employ Composite Sync

(Csync) signals or embedded Sync-on-Green (SOG), Hsync

includes equalization pulses or other distortions during Vsync. To

avoid upsetting the clock generator during Vsync, it is important

to ignore these distortions. If the pixel clock PLL sees extraneous

pulses, it will attempt to lock to this new frequency and will

have changed frequency by the end of the Vsync period. It will

then take a few lines of correct Hsync timing to recover at the

beginning of a new frame, resulting in a “tearing” of the image

at the top of the display.

The COAST function is provided to eliminate this problem. It

is an internally generated signal, created by the sync processing

engine that disables the PLL input and allows the clock to free-run

at its then-current frequency. The PLL can free-run for several

lines without significant frequency drift.

AD9882/PCB Datasheet(PDF) 17 Page - Analog Devices

AD9882/PCB Datasheet(HTML) 17 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Datasheet Descarga

Enlace URL