CS89712 datasheet(32/170 Pages) CIRRUS

32 / 170 page

CS89712

DS502PP2

2.17.1

Codec Sound Interface

The codec interface allows direct connection of a

telephony type codec to the CS89712. It provides

all the necessary clocks and timing pulses. It also

performs a parallel to serial conversion or vice ver-

sa on the data stream to or from the external codec

device. The interface is full duplex and contains

two separate data FIFOs (16 deep by 8-bits, one for

the receive data, another for the transmit data).

Data is transferred to or from the codec at

64 kbits/s. The data is either written to or read from

the appropriate 16-byte FIFO. If enabled, a codec

interrupt (CSINT) will be generated after every

8 bytes are transferred (FIFO half full/empty). This

means the interrupt rate will be every 1 msec, with

a latency of 1 msec.

Transmit and receive modes are enabled by assert-

ing high both the CDENRX and CDENTX codec

enable bits in the SYSCON1 register.

Note:

Both the CDENRX and CDENTX enable bits

should be asserted in tandem for data to be

transmitted or received. The reason for this is

that the interrupt generation will occur 1 msec

after one of the FIFOs is enabled. For example:

If the receive FIFO gets enabled first and the

transmit FIFO at a later time, the interrupt will

occur 1 msec after the receive FIFO is enabled.

After the first interrupt occurs, the receive FIFO

will be half full. However, it will not be possible

to know how full the transmit FIFO will be since

it was enabled at a later time. Thus, it is

possible to unintentionally overwrite data

already in the transmit FIFO (See Figure 5).

2.17.1.1

Codec Interrupt Timing

After the CDENRX and CDENTX enable bits are

asserted, the corresponding FIFOs become en-

abled. When both FIFOs are disabled, the FIFO sta-

tus flag CRXFE is set and CTXFF is cleared so that

the FIFOs appear empty. Additionally, if the

CDENTX bit is low, the PCMOUT output is dis-

abled. Asserting either of the enable bits causes the

sync and interrupt generation logic to activate; oth-

erwise they are disabled to conserve power.

Data is loaded into the transmit FIFO by writing to

the CODR register. At the beginning of a transmit

cycle, this data is loaded into a shift/load register.

CDENRX

CDENTX

CSINT

1 ms

Figure 5. Codec Interrupt Timing

CS89712 Datasheet(PDF) 32 Page - Cirrus Logic

CS89712 Datasheet(HTML) 32 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL