AD9396SLASHPCB datasheet(18/48 Pages) AD

18 / 48 page

AD9396

Rev. 0 | Page 18 of 48

HSYNC Filter and Regenerator

The HSYNC filter is used to eliminate any extraneous pulses

from the HSYNC or SOGIN inputs, outputting a clean, low

jitter signal that is appropriate for mode detection and clock

generation. The HSYNC regenerator is used to re-create a clean,

although not low jitter, HSYNC signal that can be used for

mode detection and counting HSYNCs per VSYNC. The

HSYNC regenerator has a high degree of tolerance to

extraneous and missing pulses on the HSYNC input, but is not

appropriate for use by the PLL in creating the pixel clock

because of jitter.

The HSYNC regenerator runs automatically and requires no

setup to operate. The HSYNC filter requires setting up a filter

window. The filter window sets a periodic window of time

around the regenerated HSYNC leading edge where valid

HSYNCs are allowed to occur. The general idea is that

extraneous pulses on the sync input occur outside of this filter

window and thus are filtered out. To set the filter window

timing, program a value (x) into Register 0x20. The resulting

filter window time is ±x times 25 ns around the regenerated

HSYNC leading edge. Just as for the sync separator threshold

multiplier, allow a ±20% variance in the 25 ns multiplier to

account for all operating conditions (20 ns to 30 ns range).

A second output from the HSYNC filter is a status bit

(Register 0x16[0]) that tells whether extraneous pulses are

present on the incoming sync signal. Extraneous pulses are

often included for copy protection purposes; this status bit can

be used to detect that.

The filtered HSYNC (rather than the raw HSYNC/SOGIN

signal) for pixel clock generation by the PLL is controlled by

raw HSYNC/SOGIN signal) for sync processing is controlled by

HSYNC is recommended. See Figure 10 for an illustration of a

filtered HSYNC.

HSOUT

VSYNC

FILTER

WINDOW

EXPECTED

EDGE

FILTER

WINDOW

EQUALIZATION

PULSES

HSIN

Figure 10. Sync Processing Filter

AD9396/PCB Datasheet(PDF) 18 Page - Analog Devices

AD9396/PCB Datasheet(HTML) 18 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Datasheet Descarga

Enlace URL