AS3525 datasheet(72/194 Pages) AMSCO

72 / 194 page

AS3525-A/-B C22O22

Data Sheet, Confidential

www.austriamicrosystems.com

Revision 1.13

- 194

7.3.11 NAND Flash Interface

The NAND FLASH interface module enables control of NAND flash devices. The design follows the hardware reference implementation described

in SMIL (SmartMediaTM Interface Library), Hardware Edition 1.00, TOSHIBA Corporation, but has extensions to support the latest generation of

NAND flash devices.

Programming and Reading can be done either by direct access to/from data register (normal mode) or by using a FIFO (burst mode). NAF supports

8-bit and 16-bit transfers.

Features

•

interface compliant to AMBA APB bus

•

generation of interrupt request signal with several maskable interrupt sources (ready, empty, almost_empty…)

•

hardware error detection (2 detect, 1 correct per 256 bytes block) for up to 8 *256 bytes (up to 24 ECC bytes)

•

8-bit and 16-bit transfer Mode fore X8/X16 devices

•

big endian / little endian support

•

DMA Mode

•

Normal Mode

•

Data/Mode/Status Register

•

write/read on/from data register automatically generates read/write strobes

•

Burst Transfer

•

36 x 32 bit FIFO for DMA/burst support

•

read- & write controller for automatic data resizing (32bit <=> 8/16bit) and read/write control

•

configurable strobe (low and high time) for higher PCLK clocks / lower speed NAND Flash devices

•

little endian/ big endian selectable

•

load interrupts when FIFO is ‘almost_empty’ & ’almost_full’ to ensure continuous data flow

Figure 31 Block Diagram of NAND Flash Interface

AS3525 Datasheet(PDF) 72 Page - ams AG

AS3525 Datasheet(HTML) 72 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL