UPD17708 datasheet(150/356 Pages) NEC

No. de pieza	UPD17708

Descripción Electrónicos	4-BIT SINGLE-CHIP MICROCONTROLLERS WITH DEDICATED HARDWARE FOR DIGITAL TUNING SYSTEM

PDF	356 Pages

Scroll/Zoom	100%

Fabricante Electrónico	NEC [NEC]

Página de inicio	http://www.nec.com/

Logo

150 / 356 page

µPD17704, 17705, 17707, 17708, 17709

150

13.2 Basic Timer 0

13.2.1 Outline of basic timer 0

Figure 13-2 outlines basic timer 0.

Basic timer 0 is used as a timer by detecting in software the BTM0CY flag that is set at fixed intervals (100,

50, 20, or 10 ms).

If the BTM0CY flag is read first after power-ON reset, “0” is always read. After that, the flag is set to “1” at

fixed intervals.

If the CE pin goes high, CE reset is effected in synchronization with the timing at which the BTM0CY flag is

set next.

Therefore, a power failure can be detected by reading the content of the BTM0CY flag at system reset (power-

ON reset or CE reset).

For the details of power failure detection, refer to 21. RESET.

Figure 13-2. Outline of Basic Timer 0

Remarks 1. BTM0CK1 and BTM0CK0 (bits 1 and 0 of basic timer 0 clock selection register: refer to Figure

13-3) set the time intervals at which the BTM0CY flag is set.

2. BTM0CY (bit 0 of basic timer 0 carry register: refer to Figure 13-4) detects the status of the

flip-flop.

Divider

Clock selection block

4.5 MHz

BTM0CY flag

Selector

BTM0CK0 flag

BTM0CK1 flag

Flip-flop

UPD17708 Datasheet(PDF) 150 Page - NEC